Titanium floater plate for bully style clutches on outlaw karts, junior sprints and clone/Predator go kart engines. It is a direct replacement for the steel bully floater plate, offered in a full run of thicknesses from .056 through .098 so you can dial the clutch stack in exactly where you want it.

Made from grade 5 6AL-4V titanium. A floater spins with the clutch, so every gram taken out of it is rotating weight the engine no longer has to accelerate off the corner — and titanium handles the heat a working clutch puts into the pack better than steel while shrugging off corrosion between teardowns.

Thickness is the tuning knob here. Stepping up or down a few thousandths changes the air gap and stack height in the pack, which changes how the clutch engages and how it holds under load. Buy a couple of sizes on either side of your baseline and you can tune the clutch at the track instead of guessing.

Material: grade 5 6AL-4V titanium
Available thicknesses: .056 through .090, plus .098
Thickness tolerance: may vary .0005 due to the sanding process
Weight: 32 g on a .075 plate
Direct replacement for the steel bully style floater plate

Choose your thickness above. Sold individually — a two or three disk pack takes more than one. Friction disks, pressure plate and drive hub are sold separately.